![]() ![]() ![]() You will need to tweak the channelValue table to actually set how many credits (well, how many keystrokes) to send. This file is meant to be used woth the arduino software and a Teensy device. As responses can sometimes change, it will always take the last responses it read on the bus. You can optionaly provide a ccSniff capture file for ccJack to learn responses. r FILE, -read=FILE File to read responses from t TIME, -time=TIME Time to listen for packets d DESTINATION, -destination=DESTINATIONĭestination address of the device to hijack Then it sends out an "Address change" request to the device and starts to respond instead of the hijacked device. You will need a UART with both RX and TX connected to the but for it to work.ĬcJack works by firstly listening for data, then learn responses made by the device to be hijacked. Just launch ccParse with a dump file as a parameter.ĬcJack is used to hijack a ccTalk device on a bus. The ccTalk messages will be displayed in the console.ĬcParse can read a data dump made by ccSniff to actually parse the data in a more comprehensive way. b, -bus-pirate Use this switch to tell the serial port is a bus h, -help show this help message and exit Just connect a UART (like a bus pirate) and start ccSniff. You can get more information about this at = ToolsĬcSniff is meant to be used as a ccTalk bus sniffer. CcTools, a collection of tools to interact with a ccTalk busĬcTalk is a protocol designed to communicate with money-related devices like coin acceptors. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |